|
|
| |
| Lighting \ CoolSpot |
Technical Information
| General Information
The CoolSpot is preferred for its extremely white, pure light output of 4800 fc, 3500K color temperature and variable spot of two inches to ten inches. An integral dimming wheel allows the user to select the right intensity for any procedure, and the beam always stays cool with the CoolSpot's double heat filtration system. The CoolSpot now comes with a new SteriHandle that accepts Burton's Light Covers and assures fingertip control for adjusting the position of the lighthead. For extra flexibility the CoolSpot head and arm may also be used with Burton Outpatient Plus in double "fixed" or track mounts.
Approvals
Listed by U.L. (Underwriters Laboratories), CSA Certified
Materials
Light Housing: Die cast aluminum
Yoke and arm/pivot adapters: aluminum
Yoke cover/arm tube: steel
Electrical Characteristics
Input Voltage: 115 Volts AC, 60 Hz, single phase (may be wired for 230volts AC, 50/60 Hz)
Input Current: 1.5 amperes (115 volts) or 0.75 amperes (230 volts)
Bulb Type: DDL tungsten halogen with integral dichroic reflector, 21.0 volts, 150 watts
Bulb Life: 500 hours average.
Power Cord: Ceiling mounts are hard wired to the house wiring. Floorstand base and wall mount have SJT 18AWG wire 6-foot long power cord with a hospital grade plug.
Power Switch: Rated 12 A at 250 vac, double pole single throw for on/off
Lamp Socket: Dual pin; ceramic
Current Leakage: Less than 100 micro amperes
Optical Characteristics| Distance (inches) (ft-cd) | Intensity | Spot Diameter | | 18 | 9,400 (FC) / 101,500 (LUX) | 4.25 (in) / 11 (cm) | | 20 | 7,200 (FC) / 77,800 (LUX) | 4.75 (in) / 12 (cm) | |
| 24 | 4,800 (FC) / 51,800 (LUX) | 6.00 (in) / 15 (cm) | | 36 | 2,000 (FC) / 21,600 (LUX) | 10.00 (in) / 25 (cm) | | 39.5 (1 meter) | 1,800 (FC) / 19,400 (LUX) | 10.75 (in) / 27 (cm) |
Color temperature: Approximately 3,500° Kelvin.
Infrared in the beam: Less than 25 milliwatts/square cm/fc (to IES standard).
Dimensions and Adjustability
Lighthead has 2" legs; 8" from head axis to end of each leg, 4" lighthead thickness, 26" (66 cm) from lighthead pivot to arm attachment axis. Lighthead supplied standard with sterilizable handle. Lighthead pivots 170 degrees on its yoke. The yoke pivots 340 degrees on the flexible arm. The flexible arm pivots 40 degrees above and below horizontal, for a total angular travel of 80 degrees.
Floorstand Base
Maximum overall dimensions: 18" (46 cm) side to side 19" (48 cm) front to back, 4.5" (11.4 cm) to top of legs. Includes four continuous swivel non-conductive casters (two locking casters)..
Floorstand Upright
Maximum overall height installed in base: 66" (168 cm) 1.50" (3.2 cm)Diameter: with head pointing down, distance from floor to front face is adjustable from 44" to72" (112 cm to 183 cm). Head and arm pivot 40 degrees between floorstand and base legs.
Single Ceiling Mount
12" (30.5 cm) diameter mounting plate and cover attaches to reinforced ceiling with three fasteners 3/88" (9.5 mm) diameter located on an 8" (203 mm) diameter hole circle, elecrical input wires routed through a 2" (50.8 mm) cutout. Contains one ceiling mount pole which allows installation in rooms with ceilings up to 9.5' height (2.89 m) based on installing the arm at 80" (203 cm) above the floor. Contains one fixed horizontal extension arm which is 17" (431.8 mm) from pivot to pivot. The extension arm pivots 320 degrees on the ceiling mounting pole. Maximum reach is 43" (1.09 m) from the ceiling pole axis to the lighthead pivot..
Double Ceiling Mount
Mounting plate, cover pole and extension arm dimensions, pivot data and reach data are same as single ceiling mount. Contains two extension arms.
Wall Mount
7" (177.8 mm) 6" (152.4 mm) wide casting attaches to a main wall structural member (stud) or reinforcement as necessary with two fasteners 3/8" (9.53 mm) diameter. Casting extends 6" (152.4 mm) away from the wall. Contains extension arm, 17" (431.8 mm) from pivot to pivot. Extension arms pivots 180 degrees on wall mount. Fleximount arm pivots approximately 320 degrees on extension arm.
Finish
All products are a light grey standard finish.
|
|
|
|
|
|
|
|
